Dell OptiPlex GX280 Manuale Utente Pagina 207

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 364
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 206
Connecting Drive Cables
When you install a drive, you connect two cables—a DC power cable and a data cable—to the back of the drive and to the
system board.
Drive Interface Connectors
IDE Drive Connector Serial ATA Connector
1 interface connector
2 interface cable
3 colored stripe on IDE cable
Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or
a filled-in hole on the other connector. Keyed connectors ensure that the pin-1 wire in the cable (indicated by the colored
stripe along one edge of the IDE cable—serial ATA cables do not use a colored stripe) goes to the pin-1 end of the connector.
The pin-1 end of a connector on a board or a card is usually indicated by a silk-screened "1" printed directly on the board or
card.
NOTICE: When you connect an IDE interface cable, do not place the colored stripe away from pin 1 of the connector.
Reversing the cable prevents the drive from operating and could damage the controller, the drive, or both.
Power Cable Connector
1 power cable
2 power input connector
Connecting and Disconnecting Drive Cables
Vedere la pagina 206
1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 363 364

Commenti su questo manuale

Nessun commento