Dell PowerEdge R610 Specifiche Scaricare il pdf (Pagina 31)

Consolidating multiple SQL Server systems onto

Dell PowerEdge R610 Servers using Microsoft’s Hyper-V

Appendix B. Installing Windows Server 2008 Enterprise Edition as the

host OS

Creating the RAID group for the host OS

Allow at least 16 minutes to complete the creation of the RAID

groups on the PowerEdge R610.

1. Turn on the server.

2. During the boot sequence, the message Press

<Ctrl><R> to Run Configuration Utility appears.

Press <Ctrl><R>.

NOTE: You have only a few seconds to do this.

3. Configure the RAID 10 for the OS and VMs.

Select the controller for the internal drives, which

is the PERC 6/i, and press Enter.

4. While highlighting Controller 0, press F2, and

select Create New VD.

5. While highlighting the RAID level field, press

Enter to open the drop-down list, and select RAID

10.

6. Using the Tab key to navigate, move to the

Physical Disks section, and use the space bar to

select all six drives. Then tab to highlight OK, and

press Enter.

7. A message box appears telling you that

initializing the RAID is highly recommended, but

destructive. Press Enter to clear the message.

8. Press <Ctrl><P> to navigate back to the Virtual

Disk Management screen. Highlight the Virtual

Disk, and press F2. Select Initialization, and then

select Fast Init. Accept Yes when the system

prompts you with a warning. After you select Fast

Init, a progress bar appears briefly, and then

disappears.

9. Exit the RAID utility, and reboot the server.

Installing Windows Server 2008 Enterprise Edition

Install Microsoft Windows Server 2008 Enterprise Edition by

following these steps. We provide approximate times for each

group of steps in the first step of that group.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 40 41

Nessun commento

Dell PowerEdge R610 Specifiche Pagina 31