Dell PowerEdge M1000e Manuale Utente

Dell 10Gb Ethernet Pass Through -k for M1000eSoftware User’s ManualRev 1.00

Software User’s ManualRev 1.0010Figure 8: Communications > Open SSH Connection6. Fill in the hostname or IP address of your system.7. Fill in the u

Rev 1.0011Figure 11: getioinfoThe 10GbE PTM is listed by the system as “10Gb PT KR” .10. Run the following command to connect to the 10GbE PTM CLI:# c

Software User’s ManualRev 1.00123 Command Line Interface (CLI) Reference10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands d

Rev 1.0013•Example: Usage example and command output.• For purpose of automation, the symbol ‘#’ is used to indicate a comment that extends until the

Software User’s ManualRev 1.0014Description:Display the current software image version.Example:3.4.2 copy image from-fileSynopsys:copy image from-file

Rev 1.00153.5 Port Commands3.5.1 show port linkSynopsys:show port link [port_number]Description:This command displays detailed port information. If an

Software User’s ManualRev 1.0016# # show port link 7Port Group Connection Downlink Uplink Status------------------------------------------------------

Rev 1.00174 Operating Procedures4.1 Procedure for Updating SoftwareThe 10GbE PTM consists of three PhyX® devices and a micro-controller (CPU). The 10G

Software User’s ManualRev 1.0018Note: The update process takes a few minutes.At the end of this process, the following message will be displayed at th

Rev 1.00195 TroubleshootingThis section provides troubleshooting information for common error conditions. If the described procedure does not solve th

Document Number: 32572Rev 1.00____________________Information in this SXEOLFDWLRQ is subject to change without notice.© 2011 Dell Inc. All rights rese

Software User’s ManualRev 1.0020chassisaction –m switch-<n> powercyclewhere <n> is the switch number [1-6].5.3 Resolving a Link Protocol M

Rev 1.003Table of ContentsAbout this Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Software User’s ManualRev 1.004About this ManualThis manual describes the installation and basic use of the Dell 10Gb Ethernet Pass Through -k for M1

Rev 1.0051 OverviewThis manual explains the use of the embedded software management of the 10GbE PTM. It explains how to connect to the 10GbE PTM and

Software User’s ManualRev 1.006• Downlink (server blade) does not support the link protocol of the port group to which it is attached• Uplink (remote

Rev 1.0071.5 10GbE PTM Status LightsThe 10GbE PTM Status lights indicate whether the switch is receiving power from the chassis, and the state of the

Software User’s ManualRev 1.0082 Connecting to the 10GbE PTM CLIIf you are connecting to the system over a network, you will need an SSH client that s

Rev 1.009Figure 6: Setup > Terminal Settings3. Select Emulation type => SCOANSI/ANSI and VT100.4. Select Backspace Character => Control-HFigu